
Secure the gutter guard mesh to the edge of the gutter using screws.
Roll out mesh along the gutter using mesh roll.
Keep on rolling out the mesh until you reach the full length of your gutters.
Carefully position the angle trims.
Secure the gutter guard mesh by screwing the trim into place.
Overlap the holes at the end of each trim.
Cut in around the ridge caps.
Secure the mesh to the gutter with angle trim.
Roll out the gutter guard mesh. Make sure to allow for flap.
Make relief cuts along the gutter guard mesh.
Cut across the nose of the second course of roof tiles. Allow approximately 10-15mm extra space.
Precisely cut around cap. Allow 10-15mm extra space.
Allow for mitre join.
Tuck the flaps under the roof tiles.
Firmly press the gutter guard mesh onto the nose of the roof tiles. Apply silicone for secure bond.
The tile roof gutter guard 500mm aluminium mesh is installed successfully.
Position yourself on top of the roof valley with the DIY gutter guard kit for tile valleys.
Roll the gutter guard mesh down the roof valley.
Make sure to roll out the valley gutter guard mesh properly and allow for some extra past the gutter.
Allow for extra mesh to go past your gutters.
Precisely cut around the ridge capping. Allow 10-15mm extra for silicone or flexi point.
Make cut along the edge of the capping.
Attach gutter guard mesh to the capping.
Make cuts down the edge of the roof tiles. Remember to allow for flap.
Carefully lift the tile and securely tuck the flap under it.
All-Flow’s dedicated, friendly team are always available to assist with your enquiries, so please don’t hesitate to get in touch.
Address: 5/148 Industrial Road, Oak Flats, NSW 2529
Free Call: 1800 033 116
Telephone: 02 4228 4266
CSIRO TESTED
Fire Rated: AS 1530-2-1993
Have A Question? Speak To Our Friendly Team.
Freecall 1800 033 116
Or Email Us Here